Hi Ben,
You have found the answer to your question already (almost).
What you see in the screen shot is the number of processes that a load will utilize in source system AT THE MAX.
If you need to change the values then you need to follow the below path in your source system.
- SBIW
- Data Transfer to the SAP Business Information Warehouse
- Maintain Control Parameters for Data Transfer
- New Entries
- Save
Once you do these changes, you need to wait for some time to see it reflecting in the above screen shot place. Sometimes it reflects immediately, sometimes after 5/10 minutes. After that when the IP is triggered the IP will not occupy more than this number of processes.
Regards,
Sujit.